Product Description:

TEMPRA PLASTIC EMULSION PAINT is a matt water based emulsion based on styrene-acrylic and vinyl acetate copolymers with excellent coating and hiding power, providing a highly protective smooth finish for interior surfaces. Its high resin content, selected minerals and additives enhance its hydrophobic properties, however at the same time keeping the transpirability of the substrate thus enhancing easy loss by evaporation from the coated surface. Excellent washability.

Recommended Use:

Easy to apply, with an excellent spreading rate, and an adequate recoating interval to avoid overlapping defects. High resistance to micro-cracking of the construction material due to internal movement or thermal expansion. The product is ideal for both exterior and interior wall on all types of surfaces, such as masonry, brickwork, concrete etc., where a high quality and protective finish is demanded. Many colours are available from the TEMPRA MULTICOLOR BANK apart from the White and Magnolia standard colours.

Technical Information:

Colour:	White, Magnolia and TEMPRA MULTICOLOR BANK.
Solids (% by volume)*1:	39% +/- 2%.
Specific gravity:	1.3 +/- 2.
Flash Point:	Not flammable.
Aspect:	Matt, fine smooth finish.
Wet Film Thickness:	110 µm.
Dry Film Thickness:	35 µm.
Theoretical Spreading Rate:	9.1m² / Lt.
Practical Spreading Rate:	7.0m² / Lt. (with 20% loss).

*1 Measured according to ISO 3233:1998 (E).

Application Data:

Application Tools:
Conventional Spray, Brush, or Roller. USE ONLY WATER with a light detergent.

Cleaning Solvent:
USE ONLY WATER with a light detergent.

Tool Cleaning:
USE ONLY WATER. Cleaning operation must be done immediately after job has been terminated. Cleaning operation must be performed fast not to allow the highly adhering binders to dry. Once dry the product is very difficult to clean from the tool.

Guiding Data Airless Spray:

Pressure at nozzle:	15Mpa (150 kp/cm2, 2100 psi)
Nozzle tip:	0,021”
Spray angle:	65-80º

Surface Preparation:

New Surfaces

Surfaces must be clean and dry, free from loose material and dust. In case of a porous surface, a first coat using TEMPRA EMULSION PAINT diluted to not less than 50% (2:1) with WATER ONLY must be applied.

Old Surfaces

All loose particles must be sanded down. Surfaces must be adequately degreased, washed with fresh water and allowed to dry.

Application Conditions:

The temperatures and relative humidity should be such that no condensation can form on the substrate. The temperature should be min. 5ºC when applied.

Packages:

Available in 2.5 Lt., 5 Lt., and 10 Lt.